Sensors / Detectors Products
-
High Power Detector For Laser Power Measurement: HP15KW-TUBE
3/9/2021
Gentec-EO introduces the HP15KW-TUBE, a high-power detector for laser power measurement up to 15,000 W. This detector, a high-power water-cooled meter, is less sensitive to variations in water cooling temperature than other comparable products in the market.
-
Irradiance And Dosage Sensor For Narrowband And Broadband Sources: Ophir® PD300RM-UVA
3/2/2021
Ophir offers the PD300RM-UVA irradiance and dosage sensor is designed for measuring sources at different wavelengths simultaneously in the spectral range, without the need to know the exact wavelength. This laser radiometer can replace a traditional radiometer that is calibrated to a single wavelength.
-
Pyroelectric DLaTGS Detectors
2/8/2021
Laser Components offer pyroelectric detectors designed to create an electric signal due to temperature changes in the chip. Deuterated Lanthanum α Alanine doped TriGlycine Sulphate (DLaTGS) detectors specifically exhibit the most effective pyroelectric effect known. Although there are many other possible uses, the major application for these detectors is FTIR spectroscopy.
-
UV-Enhanced Detector With 5.5 mm Diameter Active Area: UVG20S
11/18/2020
Opto Diode offers a new ultraviolet-enhanced detector featuring UV detection between 190 nm and 400 nm spectral wavelength, with a full spectrum of 190 nm out of 1000 nm. The device features stable responsivity over wide temperature ranges and 100% internal quantum efficiency from 200 to 400 nm.
-
Water Cooled Thermal Power/Energy Laser Measurement Sensor For High Powers: 10K-W-BB-45
9/2/2020
Ophir Photonics offers the 10K-W-BB-45 water cooled thermal power/energy laser measurement sensor designed for very high powers with a 45 mm aperture. The device can measure power from 100W to 11,000W and features a deflecting cone and annular absorber that withstands high power densities to 10kW/cm².
-
UP19K-15S-H5-D0: Thermal Detector For Laser Power Measurement Up To 15 W
8/7/2020
The UP19K-15S-H5-D0 is a thermal detector designed for laser power measurement up to 15 W. Its modular concept design increases the power capability with five different cooling modules.
-
QE25SP-S-MT-D0: Pyroelectric Detector For Laser Energy Measurement
8/6/2020
The QE25SP-S-MT-D0 is a pyroelectric detector designed for laser energy measurements up to 3.0 J with a noise level down to 2 µJ for the MB coating. The modular design concept increases the power capabilities and uses two different cooling modules.
-
10 pW – 300mW Standard Photodiode Sensors
7/30/2020
Ophir Photonics offers a series of wide spectral range photodiode laser measurement sensors for power ranges from 200 to 1800 nm within the UV and IR spectral ranges. Available models include the PD300-UV/IR without a filter for lowest powers from 200 to 1100 nm, the PD300-UV/IR with an installed filter for powers from 700 – 1800 nm, and the PD300-IRG for telecom wavelength fiber and free space measurements.
-
High Sensitivity Thermal Sensors
7/30/2020
Ophir Photonics offers a series of very sensitive thermal power/energy laser measurement sensors designed with very low noise and drift to measure very low powers and energies. Available models include those calibrated for Terahertz radiation, those with a removable window, and those for divergent beams with windows that block infrared.
-
Low Noise Lock-In Power Sensors: RM9 Series
7/30/2020
The RM9 series of radiometers are designed to use a pyroelectric or photodiode sensor in conjunction with chopped CW or quasi CW radiation, using a digitally synthesized lock-in amplifier to reduce external noise to a minimum. The signal is passed through the 18 Hz chopper and the chopped signal is detected by the sensor. All signals not at the 18 Hz frequency are suppressed.